I am towards the end of adding a bathroom to my basement and I am struggling with how to finish the corners where the shower travertine tile and the sheet rock meet. Part of my challenge is I have already installed the tile and sheetrock and did not plan the final details of how I was going to finish the corner.
Any suggestions on how to finish the corner?
the tile and the sheetrock meet on a corner. Currently the sheetrock meets the backer board for the tile and the tile meets the back of the sheetrock ... so I don't really have a corner. I tried to make a diagram of the situation below.
(Sheetrock)
___
OOl_ (notched out void in corner)
OOOl
OOOl (tile)
(the "O"s are the interior of the wall)
Frankly, I didn't understand your diagram.
But if you can't finish the corner in a nice looking manner, you can use trim tiles to cover any imperfection.
To get some ideas, check pictures in tile remodeling articles.
dj1 ... I tried to attached a photo, but was having technical problems. Thank you for your advice.
Here's a solution: send your photo to our distinguished member JLMcdaniel, and he'll gladly post it for you. Tell him DJ1 sent you.
:)