How to Repair Vinyl Siding
In this how-to video, This Old House general contractor Tom Silva replaces damaged vinyl siding
In this video, This Old House general contractor Tom Silva explains how to repair vinyl siding.
1. Cut piece of faded siding from an inconspicuous spot to replace the damaged section; it'll better match the house than brand-new siding.
2. Use framing square and utility knife to cut through face of siding.
3. Pull siding away from house and cut through the bottom edge with aviation snips.
4. Use zip tool to disengage top of siding from the course above.
5. Lift up the course above and pull the nails holding siding to wall.
6. Cut out the damaged piece of siding, leaving a space 2 inches shorter than the replacement piece.
7. Use the snips to cut away about two inches of the top nailing strip and the bottom J-profile from both ends of the replacement piece.
8. Install the replacement piece over the existing siding, and attach with roofing nails.
9. Slide the zip tool along the bottom edge to engage the new piece with the course below.
10. Install the new piece of siding to inconspicuous place where patch was cut out.
See products and services from this episode.