-
Overview
-
-
In this video, learn how to build a toy chest.
Steps:
1. Lay out the pieces of the box on some plywood. Clamp down the wood and cut the pieces out with a jigsaw.
2. Using a random-orbit sander, sand all the parts with 120-grit paper.
3. Glue and nail the bottom part of the box together.
4. Clamp the gable ends on top of the sides, using a scrap block to brace them and hold them upright. Glue and nail the roof onto the gable ends.
5. Screw casters to the bottom of the chest.
6. Paint the barn red with white trim and the roof silver.
7. Screw a piano hinge to the joint between the roof and the back of the base. Then screw on soft-close hinges at both ends of the roof.
• Download a template for this project
• Share a project you’ve built -
-
5 hours
-
$95
-
Tools
-
Shopping List
-
Difficulty: Moderate
Fitting the parts together takes a little extra patience.
-
Video Directory
Selected Topic/Section
- TV Shows
- Most Viewed
- Kitchen
- Bathroom
- Living Spaces
- Workspaces
- Landscaping
- Exterior
- Remodels & Upgrades
- Money
- Interior
- House Exterior
- Molding & Carpentry
- Flooring
- Painting & Finishes
- Yard & Garden
- Framing & Insulation
- Plumbing, HVAC & Electrical
- Basements & Foundations
- Upkeep
- Health & Safety
- Tools
- TOH Specials
Tools List
-
Tape measure
-
Combination square
-
Straightedge
-
Adjustable clamps
-
Safety glasses
-
Jigsaw
-
Random-orbit sander
-
36-inch bar clamp
-
Hammer and nailset
-
Drill/driver fitted with ⅜-inch bit
-
Putty knife
-
Small paint rollers and brush
-
Screwdriver
Shopping List
1. 4-by-4-foot piece of ½-inch birch plywood
2. 120-grit sandpaper
3. Stainable wood glue
4. Rag
5. 4d finish nails
6. Stainable wood putty 7. Four 2-inch casters
8. Satin-finish latex paint in red, white, and silver
9. Painter’s tape
10. 30-inch continuous hinge
11. Two toy box spring lid supports (one left and one right)
2. 120-grit sandpaper
3. Stainable wood glue
4. Rag
5. 4d finish nails
6. Stainable wood putty 7. Four 2-inch casters
8. Satin-finish latex paint in red, white, and silver
9. Painter’s tape
10. 30-inch continuous hinge
11. Two toy box spring lid supports (one left and one right)
Contribute to This Story Below