Illustration: Gregory Nemec
«»
Measure 18 inches up from the mark and wrap this section with ¾-inch pressure-treated plywood.
Step 2: Build Out the Base
Introduction
Overview
Step 1
Divide Up the Post
Step 2
Build Out the Base
Step 3
Panel the Sides
Step 4
Build the Mailbox Support
Step 5
Install the Mailbox
More in Landscaping
Tools List
-
Miter Saw
-
Jigsaw
-
Drill Driver
-
Hammer
-
Speed Square
-
100-grit Sandpaper
-
Polyester Nylon Paintbrush
Shopping List
1. Pressure Treated Lumber a 4x4 post, 2x2, 2x6, and a 1x
2. ¾-inch Pressure Treated Plywood to sheath the base of the post.
3. ½-by-1½-inch Lattice and Molding Choose a baseboard, small crown molding and window bead to trim the post.
4. Post Cap a 5x5 cap will cover the post and decorative sheathing. 5. Mailbox
6. 1 5/8-inch and 3-inch Deck Screws
7. Stainless Steel Siding Nails
8. Acrylic Adhesive Caulk
9. Exterior Latex Primer and Paint
2. ¾-inch Pressure Treated Plywood to sheath the base of the post.
3. ½-by-1½-inch Lattice and Molding Choose a baseboard, small crown molding and window bead to trim the post.
4. Post Cap a 5x5 cap will cover the post and decorative sheathing. 5. Mailbox
6. 1 5/8-inch and 3-inch Deck Screws
7. Stainless Steel Siding Nails
8. Acrylic Adhesive Caulk
9. Exterior Latex Primer and Paint
Contribute to This Story Below