How to Set Up a Ladder
In order to be safe, a ladder needs to remain stationary. Period. And setting it up right is at least half the battle. Here's what proper placement looks like
"I know a lot of people—professionals, even—who have been hurt only because they tried to take a shortcut when setting up their ladders," says This Old House general contractor Tom Silva.
In order to be safe, a ladder needs to remain stationary. Period. And setting it up right is at least half the battle. Here's what proper placement looks like.
On hard, dry ground, rest feet (with textured-rubber pads intact) flat, free of slippery plastic tarps and debris.
On grass or soft ground, flip the feet up and drive their spiked ends into the ground, or lay the feet flat and tie them down on the side (or brace them in front) with 1x2 stakes.
Position the ladder so that the distance from its base to the wall is one-quarter of the height of the ladder at its resting point, creating a 75-degree angle.
For a quick check on the angle of your ladder: Stand facing it with your feet touching its feet and your arms extended—your palms should rest on a rung at shoulder height.
Always look overhead for wires before you carry or set up a ladder.
Make sure ladder isn't too close to edge.
Never use ladder jacks higher than 20 feet. Above 10 feet, you must use a harness.
Position jacks on either front or back of ladder. If the planks are in front, have another ladder available for access.
Use ladder jacks on Type I or IA ladders only.
Hook ladder jacks onto two rungs of ladders.
Use only aluminum scaffolding planks meant for ladder jacks or 2x12 wood planks no more than 8 feet long.
Always position the fly section (the one with the rung locks) in front and make sure it overlaps the base section by at least 3 feet.
Extend ladder 3 feet above any surface that you're climbing onto.
Slip a 2x4 into a gutter to keep it from being crushed by the ladder.
Check rope and pulley to make sure they show no signs of wear or damage.
Hook both rung locks securely over the rungs and tie off the rope on a lower rung.
Don't rest an extension ladder against a tree or pole, where it can rotate and fall.
Check that any supports/braces beneath treads are intact.
Keep treads free of paint—which can hide defects on wood—and clean of grease and dirt.
Place feet on level, stable ground.
Open and lock rail spreaders.
Make sure any doors next to a ladder are locked or barricaded.
Remove all tools and materials from the ladder when it's not in use.