Big Wally's Plaster Magic For Easy Repairs
A new product that reattaches plaster without leaving behind difficult-to-disguise bumps
Using a 3/8-inch masonry bit, drill through the plaster on both sides of the crack. Stop drilling when you hit the wood lath.
Like death and taxes, there's a certain inevitability about the cracks that happen in plaster walls and ceilings. When a plaster wall or ceiling breaks loose from its wood lath, it has a simple way of letting you know: it cracks. That's why simply filling a crack with spackle joint compound is pointless; it just comes back. The only sure fix is to reunite plaster with its lath. For years, homeowners have done just that by screwing plaster washers into the lath and covering the cracks with mesh tape. But the washers and tape stick out from the wall and the process of covered them with layers of joint compound requires a fair amount of skill and patience.
Now there's a new product that reattaches plaster without leaving behind difficult-to-disguise bumps. Big Wally's Plaster Magic repair kit uses a two-part adhesive to glue the lath and plaster back together, so a spackle is all it takes to make the repair disappear. Rory Brennan, a Vermont-based plaster restoration expert, developed this homeowner-friendly system after years of using drums of similar adhesives on large-scale plaster-repair projects.
Drill holes on both sides of the cracks If you miss lath, mark the holes with a pencil so you know not to put any adhesive in it.
I used Big Wally's this winter on the cracked and bulging plaster in my hallway walls and ceiling. Following the directions on the package, I drilled a series of holes through the plaster, stopping when I hit the lath, then squirted the milky conditioner into the same holes (see images 1-3). The old plaster sucked this stuff up like a sponge, and became rock hard once the conditioner dried. Next I caulk-gunned the thicker adhesive into the holes and clamped the lath to the back side of the plaster with drywall screws and big plastic washers (see images 4 and 5). Neither glue has any odor to speak of, and both of them wash up with water. (As I learned, if you don't flush the conditioner out of the spray head, it gets completely gummed up.) After the glue set in a day or two, I backed out the screws, popped off the washers, and filled the holes. A quick skim coat finished the job to my satisfaction.
The images to the left show "Big Wally" himself, Rory Brennan, demonstrating technique for Ask This Old House. (Stay tuned to see Rory in action when Ask airs its sixth season on PBS in October.)
Spray the conditioner in all the holes.
So far, Big Wally's has lived up to its promise; my repairs remain solid and crack free. Just be warned that this job demands a lot of patience, an unwavering attention to detail, and a high tolerance for dust, drips, and the occasional drilling mistake. If that's not you, show your painter how Big Wally's works and let him fix your walls. (They have to be primed and painted anyway once the holes are filled.) Just be warned: once you start a repair, you'll begin to seeing more areas that need attention. Better to buy more than you think you need, than to run out of adhesive halfway through the job. (In my own particularly bad walls, one tube was sufficient for about 3 lineal feet of 8-foot wall.)
The same goes for the plastic washers. Big Wally's supplies 15 in its approx. $85 Painter's kit, but I needed many more. You can stock up with a 1,000-count container from Demandproducts for approx. $40; .