More in Doors

Installing a Prehung Exterior Door

In this how-to video, This Old House general contractor Tom Silva makes quick work of replacing an old door

In this video, This Old House general contractor Tom Silva explains how to replace an exterior door.

Steps:
1. Use drill/driver to back out door hinge screws; remove door
2. Remove screws and/or nails from the hinge-side doorjamb
3. Push old doorframe out of the opening, and discard
4. Install Z-flashing over the door casing at the top of the opening
5. Apply thick bead of caulk along the sides and top of opening
6. Set the new prehung door into place, pressing it tight against the framing
7. Check the threshold for level; slip shims under threshold, if necessary
8. Temporarily screw through hinge-side jamb, then check spacing around inside of door
9. Insert shims into spaces between the hinge-side jamb and wall framing
10. From outside, pull back weatherstripping, drill pilot holes and drive masonry screws through hinge-side jamb and into masonry wall (use decking screws for wood wall)
11. Repeat the procedure for latch-side jamb, making sure to place screws behind weatherstripping
12. Close door and check the space between latch-side jamb and door edge; tap in shims, if necessary, to create consistent spacing
13. Use utility knife to trim all shims flush
14. Install lockset
15. Apply bead of caulk around the exterior of the doorframe, including under the threshold

 
 

TV Listings

Find TV Listing for This Old House and Ask This Old House in your area.