More in Water Heaters

How to Join Steel and Copper Pipes

In this how-to This Old House plumbing and heating contractor Richard Trethewey shows how to repair an old, corroded steel-to-copper pipe connection

In this video, This Old House plumbing and heating contractor Richard Trethewey explains how to join steel and copper pipes.

Steps:

1. Turn off water and power to water heater.
2. Use garden hose to drain water from heater's tank.
3. Cut copper pipe just above the corroded connection using a tubing cutter.
4. Use two pipe wrenches to loosen the old union.
5. Remove the old union from the steel pipe.
6. Wrap threads on end of the steel pipe with Teflon tape.
7. Install the lower half of the dielectric union to steel pipe; tighten first with pliers, then with pipe wrench.
8. Solder coupling and small length of pipe to end of existing copper water pipe.
9. Remove the rubber gasket from dielectric union.
10. Solder top half of union to copper pipe.
11. Allow union to cool, then replace the rubber gasket.
12. Use wrench to tighten together the two halves of the union.
13. Turn power and water back on, and check for leaks.

 
 

TV Listings

Find TV Listing for This Old House and Ask This Old House in your area.