More in Doors

How to Install a Vintage Lockset

This Old House general contractor Tom Silva shares his tricks of the trade for installing a mortised lockset

In this video, This Old House general contractor Tom Silva shares his tricks of the trade for installing a mortised lockset.

Steps:
1. Hold the lockset's escutcheon plate on the door and mark the doorknob hole onto the vertical rail approximately 36 inches from the door bottom.
2. Trace the lock mortise onto the door rail, and mark the hole for the doorknob.
3. Use a combination square to mark the mortise outline onto the edge of the door. Mark a centerline down the edge of the door, too.
4. Stand the door on edge and mount a portable drill press drill onto an electric drill.
5. Make a jig from two 2x6s and two plywood blocks. Set the jig onto door edge and bore out the mortise with a spade bit. Vacuum out the wood chips from the mortise.
6. Use a chisel to remove the excess waste from the holes and square up the mortise.
7. Set the lock into the mortise, and trace around the lock plate with a utility knife.
8. Chisel out around the mortise until the lock plate sits flush with the door edge.
9. Clamp a scrap board to the backside of the door and drill the doorknob hole through door.

 
 

TV Listings

Find TV Listing for This Old House and Ask This Old House in your area.