Steps // How to Build a Boot Stand
1 ×

#### Overview

Step One // How to Build a Boot Stand

## Overview

Photo by Lisa Shin

Cut list to build a boot stand:
Balusters: eight @ 23 inches long, with uniform base heights cut to 10°

Boot-rack base: one 2x6 cut with 45° angled ends and to 24 inches between long points

Boot-rack feet: two 2x4s cut with 45° angled ends and to 8 ½ inches between long points

2 ×

#### Cut the Balusters

Step Two // How to Build a Boot Stand

## Cut the Balusters

Photo by Lisa Shin

Use a boot to determine where to cut your balusters. Trim the lengths off the baluster tops accordingly. Cut the bases at a 10° angle. We left about 8 inches of baluster beyond the opening of an adult-size boot.

3 ×

#### Drill Pilot Holes

Step Three // How to Build a Boot Stand

## Drill Pilot Holes

Photo by Lisa Shin

On the bottom of each baluster, draw an x connecting the corners. Center a ¼-inch pilot hole where the lines intersect.

4 ×

#### Make the Base

Step Four // How to Build a Boot Stand

## Make the Base

Photo by Lisa Shin

Find the center line of a 2x6 board. Using the bottom of the baluster as a measuring guide, determine the length of your base and the spacing of your balusters. (Our baluster base is 1¼ inches square. We came in 2½ inches and left a 1 ¼-inch space between each baluster.) Once you've determined the length, cut the 2x6. (Ours is 24 inches long.) Detail the ends of the base by cutting a 45° angle on edge and then making a straight cut and snubbing off the pointed ends.

5 ×

#### Drill Holes for the Balusters

Step Five // How to Build a Boot Stand

## Drill Holes for the Balusters

Photo by Lisa Shin

Find the center of each of the spaces where you want the balusters to go. Using your marks as a guide, drill holes in the base with the ¼-inch bit. Using the ⅜-inch paddle bit, recess and widen the second pilot holes from each end on the underside to countersink the fastener heads covered by the feet.

6 ×

#### Attach the Balusters

Step Six // How to Build a Boot Stand

## Attach the Balusters

Photo by Lisa Shin

Using the socket wrench, tighten the lag screws through the bottom of the base into the balusters.

7 ×

#### Attach the Feet and Finish Attaching the Balusters

Step Seven // How to Build a Boot Stand

## Attach the Feet and Finish Attaching the Balusters

Photo by Lisa Shin

Echo the detailed ends of the base on the 2x4, snubbing the ends, to make the feet. (Our feet are 8½ inches long.) Using the drill/driver, screw the feet to the base with 2½-inch deck screws. Finish attaching the rest of the balusters. Prime and paint.

\$8.46 \$10.25

\$4.99 \$4.99

\$19.99 \$19.99

## DEWALT Sliding Compound Miter Saw, 12-Inch (DWS779)

Too low to display \$469.00

\$2.59 \$6.93

## CRAFTSMAN Tape Measure, Chrome Classic, 25-Foot (CMHT37325S)

Too low to display \$8.98

\$3.58 \$4.38

\$52.95 \$52.95