More in Patio

Sinking Brick Patio

Q: How do I fix a sinking brick patio?

setting brick into a brick patio
Photo by Charles Brown

Years ago, I laid a brick-on-sand patio. At the time, the brick was flush with the top of a 6-inch-diameter cast-iron pipe cleanout. Now the pipe sticks up about 2 inches above the brick. How can I fix this problem?
C.J. Bosch, Woodcliff Lake, N.J.


Roger Cook replies: Two inches is a lot for a brick patio to sink, but if that's what's going on, the dip will be obvious when you lay a 4-foot level or metal straightedge across the area. Lift out the sunken bricks with a flat pry bar, add enough sand to bring them back to level, then tap them back into place with a rubber mallet.

Of course, it's possible that the bricks are fine and the pipe has lifted. Sometimes a length of pipe is slipped over another to provide extra stiffness, and the freeze-thaw cycle can push up the outer sleeve over time. To fix, remove the bricks around the pipe, dig a few inches, then have a plumber verify the situation. If he confirms that the pipe is sleeved, tap it down using a scrap of 2x4 and a 3-pound hammer. If you try to drive the pipe deeper and it's not a sleeve, you'll have an expensive repair project on your hands. When the pipe is back down where you want it, put back the sand and bricks.


TV Listings

Find TV Listing for This Old House and Ask This Old House in your area.