• In this video, This Old House plumbing and heating expert Richard Trethewey rebuilds an old shower valve.

    Steps:
    1. Turn off the water to the shower.
    2. Remove handle and escutcheon plate to expose shower valve.
    3. Loosen locking nut with pliers and pull old cartridge from center of valve.
    4. Put new rubber seat with spring onto end of pencil and push into the valve. Repeat for remaining seat.
    5. Insert the new cartridge into the existing valve.
    6. Slip the O-ring over the cartridge, then tighten the locknut with pliers.
    7. Press the new escutcheon plate over the valve and secure it with the screws provided.
    8. Attach the new handle to the valve.
    9. Turn on the water and adjust the temperature to 120 degrees F.
    10. Install the temperature limit stop to the valve to prevent scalding.
    • Difficulty: Easy to moderate
Ask TOH users about Bathroom

Contribute to This Story Below

    Video Directory

    Selected Topic/Section

      Tools List

      • multi-bit screwdriver
        Screwdriver
      • slip-joint pliers
        Pliers
      • water thermometer
        Thermometer, used to measure the water temperature

      Shopping List

      Shower valve rebuild kit