How to Build a Storage Bed
By , This Old House magazine
Photo: Laura Moss
Run a bead of wood glue along the perimeter of the top of the platform, one side at a time for each panel. Place each panel on edge in the glue, and clamp it in place, as shown. Check that the face is square and flush with the platform, then drill pilot holes up into the edges from the storage bays and install 1½-inch MDF screws. Screw through the side panels and into the edges of the footboards, too.
Steps
- Introduction
- Overview
- 1. Cut the MDF Pieces
- 2. Assemble the Storage Carcasses
- 3. Dry-Fit the Carcasses
- 4. Join the Carcasses
- 5. Install the 2x4 Support Frame
- 6. Cut the MDF Bed-Frame Pieces
- 7. Install the Panels
- 8. Attach the Headboard
- 9. Install the Face Frames
- 10. Install the Cap Trim
- 11. Install the Headboard Trim
- 12. Install the Paneling
- 13. Add the Finishing Touches