How to Build a Garden Gate
By , This Old House magazine
Photo: Kolin Smith
Prop up the gate on scrap blocks between the posts, at least 2 inches above the highest point in its path, apron-side out. Shim it level, and use a level to check your work. Be sure to keep an even gap on each side. Center the gate on the posts, then shim it in place between them.
Steps
- Introduction
- Overview
- 1. Dig the Postholes
- 2. Wrap and Set the Posts
- 3. Assemble the Frame of the Gate
- 4. Mark the Crosspiece
- 5. Cut the Crosspiece
- 6. Bevel the Brace to Make the Gate's Trim
- 7. Install the Apron
- 8. Create the Pales
- 9. Cut the Edge Bevels
- 10. Install the Pales
- 11. Finish the Gate: Secure the Brace
- 12. Add and Secure the Post Caps
- 13. Shim and Level the Gate in Place
- 14. Position the Hinges
- 15. Attach the Hinges
- 16. Add the Latch and Stop