How to Build an Arbor Bench
By
Photo: Kolin Smith
Cut 1x4 and 1x2 seat and backrest boards to size, per the cut list. The first 1x4 board at the front of the seat will extend ½ inch past the front edge of the seat's base and must be notched at the ends to wrap around the front legs. Mark the notch positions, 3¾ inches from each end and 2¼ inches from the board's front edge. Use a jigsaw to cut out the notches.
Steps
- Introduction
- Overview
- 1. Make Pilot Holes for the Post Anchors
- 2. Set the Post Anchors
- 3. Level and Square the Post Anchors
- 4. Dry-fit the Pieces
- 5. Assemble the Legs
- 6. Install the Legs
- 7. Cut and Assemble the Seat Base
- 8. Attach the Base and Lower Crosspieces
- 9. Cut the Pieces and Install the Side Supports
- 10. Secure the Center Support
- 11. Cut the Seat Boards
- 12. Attach the Seat Boards
- 13. Attach the Backrest Boards and Cap the Top
- 14. Install the Remaining Crosspieces and Vertical Strips
- 15. Cut and Install Horizontal Strips
- 16. Cut the Pieces and Draw the Tail Profile
- 17. Cut the Rafter Tails
- 18. Install the Rafters
- 19. Install the Purlins