How to Build a Ricochet Game Table
By , This Old House online
Photo: Wendell Weber
Lay the long 1x4 side rails flat and parallel to each other on the work surface. Measure and make a mark 6 inches from one end of each board. From there, draw a 2-inch line starting from the top edge with a combination square. Using a jigsaw, cut the line to create a slit in each side.
Steps
- Introduction
- Overview
- 1. Apply the Finish to the Door
- 2. Tape Off and Paint the Lines
- 3. Remove the Tape
- 4. Apply the Points Graphics
- 5. Apply and Buff the Finish Coats
- 6. Cut the Sides, Ends, and Center Rail
- 7. Cut the Slit for the 1-inch Elastic
- 8. Cut the Slit for the 1-inch Elastic
- 9. Drill Holes in the Sides
- 10. Attach the Sides
- 11. Attach the Center Rail
- 12. Attach the Leg Supports
- 13. Install the Legs
- 14. Insert the Elastic