How to Anchor a Towel Bar

Photo:  Merle Henkenius

In order to install 1x4 backing, you must first cut a rectangular hole 6-inches-high and long enough to span at least two studs. If working in a corner, mark the hole outlines starting 1 ½-inches from the wall corner and extending 3 inches beyond a stud. Then, use a drywall saw to cut along the pencil lines.

Steps

• Introduction
• 1. Cut through drywall to expose studs
• 2. Notch exposed studs
• 3. Remove waste wood
• 4. Add support for backing (if working close to a corner)
• 5. Fit backing into notches
• 6. Replace and patch drywall
• 7. Apply joint compound
• 8. Install the bars

Helpful Info:

Skill Builder: Simple Stud Finder

Skill Builder: Using Hammers for Rough Measurements

Article: How to Design Small Baths So They Feel Roomier