Step 3: Glue and nail

Tom Silva applying an adhesive before wainscoting
Photo: David Carmack
«»
Apply 4 or 5 horizontal stripes of adhesive, each about a foot or two long. Slip each board's groove over the tongue of the previous one and align top edge with the layout line.

Next

Related Content

Ask TOH users about Wainscoting
Discuss

Contribute to This Story Below

Add Comment

    More in Molding & Carpentry

    Tools List

    Close
    • drill
      Drill/driver and assorted drill bits
    • two-foot level
      Levels,
      2 ft. and 4 ft.
    • pencil compass
      Compass,
      for scribing
    • coping saw
      Coping saw
    • biscuit joiner
      Biscuit joiner
    • utility knife
      Utility knife
    • nailset
      Nail set
    • caulk gun
      Caulking gun
    • jigsaw
      Jigsaw
    • combination square
      Combination square
    • 16-foot tape measure
      Tape measure
    • block plane
      Block plane
    • brad nailer
      Brad nailer
    • hammer
      Hammer,
      16 oz.
    • table saw
      Table saw
    • miter saw
      Power miter saw

    Shopping List

    Close
    1. BEADBOARD WAINSCOTING

    2. CONSTRUCTION ADHESIVE

    3. CAP RAIL

    pine or fir 1x2



    4. OGEE MOLDING



    5. BASEBOARD MOLDING

    6. CAP MOLDING

    7. SHOE MOLDING

    8. FINNISHING NAILS

    4d and 6d



    9. 3/4-INCH BRADS

    to attach ogee molding to underside of cap rail