Step 6: Notch the tile

notch the tile
Photo: David Carmack
«»
On a wet saw, cut the tile from the mark to the line, taking care not to go beyond the line. Then turn the tile and cut along the line next to the X, up to but not beyond the first cut. At end of cut, lift up the edge farthest from you to help free the waste.

For curved or scribed cuts, make parallel slices with the wet saw into the waste section, up to but not past the line marking the cut. Then break away the remaining “fingers” with nibblers.

Ask TOH users about Tile

Contribute to This Story Below

    More in Painting & Finishes

    Tools List

    • straightedge guide
      10-foot straightedge (for aligning tile
    • rubber float
      Rubber float (for spreading grout
    • notched trowel
      Notched trowel (for spreading adhesive
    • rubbing stone
      Rubbing stone (for smoothing cut tile edges
    • drill
      Drill-driver and epoxy-coated screws,
      to secure backerboard to subfloor
    • mason's trowel
      Mason's trowel (for mixing thinset and grout
    • margin trowel
      Margin trowel (for cleaning cured joint lines
    • hand saw
      Flush-cut hand saw (for undercutting trim
    • 16-foot tape measure
      Tape measure
    • tile cutter
      Tile cutter
    • power flush cut saw
      Power flush-cut saw (for undercutting trim
    • tile nippers
      Nippers (for breaking off small pieces of tile
    • carbide tipped scorer
      Carbide-tipped scorer and utility knife,
      for cutting backerboard
    • folding A-square
      Folding A-square,
      for checking squareness of tile layout)
    • wet saw
      Diamond blade,
      used with wetsaw to cut corner notches and curves in tile

    Shopping List

    1. CERAMIC FLOOR TILE

    2. THINSET MORTAR

    3. TILE GROUT

    4. TILE SPACERS

    used to ensure consistent joints



    5. MIXING PADDLE

    used in drill to mix up mortar and grout



    6. KNEE PADS

    7. FOAM SPONGE

    for wiping up grout haze