Step 4: Nail baseboard to wall

Tom Silva installing baseboard
Photo: Craig Raine
«»
Set the scribed baseboard in place. Next, at each stud location, hammer two 8d finish nails through the board, at a slight downward angle, near its top and bottom edges. To avoid marking the wood, use a nail set to drive the heads just below the wood surface.

Next

Related Content

Ask TOH users about Trim
Discuss

Contribute to This Story Below

Add Comment

    More in Molding & Carpentry

    Tools List

    Close
    • miter saw
      Compound miter saw,
      for straight and angled crosscuts
    • coping saw
      Coping saw,
      for cutting copes in the ends of molding
    • four-foot level
      4-foot level,
      for finding low spots on floor and marking height of baseboard
    • circular saw
      6-inch circular saw,
      for ripping back-bevels in trim
    • speed square
      Speed Square,
      for guiding crosscuts made with a circular saw
    • 30-foot tape measure
      25-foot tape measure
    • pencil compass
      Compass (for scribing
    • block plane
      Block plane,
      for tuning the fit of a scribed piece
    • biscuit joiner
      Biscuit joiner,
      for cutting slots in miter joints
    • chalk line
      Chalk line,
      for snapping the lines that establish baseboard height
    • hammer
      Hammer or pneumatic nail gun
    • nailset
      Nail set

    Shopping List

    Close
    1. BASEBOARD MOLDING

    2. CAP MOLDING

    3. SHOE MOLDING

    4. 6D AND 8D FINISH NAILS

    5. NO. 10 COMPRESSED WOOD BISCUITS
    (for holding together baseboard miters)

    6. CARPENTER'S GLUR
    (for adhering joints)