«»
If there is no glass side panel, slip the magnetic strike rail onto the remaining side jamb. Holding the rail and jamb, close the door until it lines up with the base track.
Adjust the jamb until it’s flush against the wall. Mark the wall alongside the jamb. Remove the jamb from the rail.
Align the jamb with the pencil line and mark screw hole locations.
Drill the holes for the plastic anchors. Screw the jamb to the wall.
To install a glass side panel, slip the remaining jamb onto one of the panel’s edges and the magnetic strike rail onto the other. Fit the panel into the base track. Butt the jamb against the wall.
Close the door and mark the wall along the jamb.
Remove the jamb and the magnetic rail from the panel and attach the jamb.
Slide the panel back into its jamb and base track.
Adjust the jamb until it’s flush against the wall. Mark the wall alongside the jamb. Remove the jamb from the rail.
Align the jamb with the pencil line and mark screw hole locations.
Drill the holes for the plastic anchors. Screw the jamb to the wall.
To install a glass side panel, slip the remaining jamb onto one of the panel’s edges and the magnetic strike rail onto the other. Fit the panel into the base track. Butt the jamb against the wall.
Close the door and mark the wall along the jamb.
Remove the jamb and the magnetic rail from the panel and attach the jamb.
Slide the panel back into its jamb and base track.
Contribute to This Story Below