Step 2: Set the base track

Centering the base track of a shower door «»
Place the track on the threshold and use a tape measure to make sure that it’s centered from front to back.

With a pencil, mark the threshold along the edge of the track near each end. This allows easy repositioning if it slides around during installation of the jambs.
Next

Related Content

Ask TOH users about Showers
Discuss

Contribute to This Story Below

Add Comment

    More in Bathroom

    Tools List

    Close
    • four-foot level
      4—foot level,
      for checking the jambs, door, and glass panel for plumb
    • 30-foot tape measure
      25—foot tape measure
    • caulk gun
      Caulking gun with clear, mildew—resistant silicone sealant,
      for sealing joints between frame and tile
    • automatic punch
      Automatic punch,
      for starting holes in tile
    • single cut file
      10—inch single—cut file,
      for removing burrs from aluminum pieces after cutting
    • ratcheting screwdriver
      Ratcheting screwdriver with No. 2 Phillips and straight bits
    • mallet
      Plastic mallet (for tapping in plastic anchors
    • 3/16 masonry bit
      Drill bits,
      3/16-inch masonry bit for boring holes in tile and 7/32- and 3/16-inch twist bits for pilot holes in aluminum
    • drill
      Drill
    • hack saw
      Hacksaw with 32-tpi blade,
      for trimming the aluminum base track and drip rail
    • utility knife
      Utility knife,
      for trimming vinyl sweep
    • shop vacuum
      Wet/dry vacuum,
      for picking up dust and metal chips

    Shopping List

    Close
    1. SHOWER DOOR AND FRAME

    2. CANVAS DROP CLOTH

    for protecting the floor



    3. GLASS CLEANER AND PAPER TOWELS

    for cleaning shower door and panel after installation.



    4. ISOPROPYL RUBBING ALCOHOL

    for cleaning walls and threshold before caulking