gluing the frame pieces
Photo: Kolin Smith

Step 7: Apply the Frames

Align a ½-inch spacer along the short edge of a side panel to set the overhang for the plywood of the abutting panel. Apply construction adhesive to the plywood, as shown, then press one of the ripped-down stiles in place. Use your drill/driver to secure the stile with three evenly spaced 1¼-inch deck screws. Make one more panel this way. To make the two panels that sandwich the first two, use a ¾-inch spacer to set the stiles' overhang. Glue and screw the rails between the stiles.
Ask TOH users about Pools, Ponds & Fountains

Contribute to This Story Below

    Tools List

    • miter saw
      miter saw
    • bar clamps
      bar clamps
    • drill
    • hammer
    • steel-rule straightedge
    • combination square
      combination square
    • Countersink bit
      countersink bit
    • jigsaw
    • circular saw
      circular saw
    • caulk gun
      caulk gun
    • staple gun
      staple gun
    • handsaw
    • utility knife
      utility knife

    Shopping List

    ½x6 treated deck boards Get four 6-footers for the floorboards and stringers.

    ½x4 treated boards Get four 8-footers for the skirt and cap.

    1x4 treated boards Get seven 6-footers for the panel frames and interior battens.

    ½-inch treated plywood Get one 4-by-8-foot sheet for the side panels.

    1¼-, 1½-, and 2-inch deck screws

    3-inch stainless- or galvanized-steel corner brackets Get eight.

    construction adhesive

    landscape fabric

    pond liner

    submersible pond pump

    exterior-grade wood stain

    plant pots