Step 5: Attach the Skirtboards

attaching the skirt to the base
Photo: Kolin Smith
«»
Flip the base assembly upside down on your work surface. Set ½ spacers at the corners to even up the top edge of the skirtboards with the stringers. Arrange the skirtboards upside down, framed around the base. Use a combination countersink bit to drill pilot holes, then drive two 2-inch deck screws through the skirtboards and into the ends of the stringers, as shown. For the skirtboards parallel with the stringers, drive screws every 6 inches into the stringers' edges.
Ask TOH users about Pools, Ponds & Fountains

Contribute to This Story Below

    Tools List

    • miter saw
      miter saw
    • bar clamps
      bar clamps
    • drill
      drill/driver
    • hammer
      hammer
    • steel-rule straightedge
      straightedge
    • combination square
      combination square
    • Countersink bit
      countersink bit
    • jigsaw
      jigsaw
    • circular saw
      circular saw
    • caulk gun
      caulk gun
    • staple gun
      staple gun
    • handsaw
      handsaw
    • utility knife
      utility knife

    Shopping List

    ½x6 treated deck boards Get four 6-footers for the floorboards and stringers.

    ½x4 treated boards Get four 8-footers for the skirt and cap.

    1x4 treated boards Get seven 6-footers for the panel frames and interior battens.

    ½-inch treated plywood Get one 4-by-8-foot sheet for the side panels.

    1¼-, 1½-, and 2-inch deck screws

    3-inch stainless- or galvanized-steel corner brackets Get eight.

    construction adhesive

    landscape fabric

    pond liner

    submersible pond pump

    exterior-grade wood stain

    plant pots

    topsoil

    gravel