Step 1: Attach Stand-Off Blocks

Attach Stand-off Blocks when installing fiberglass gutters
Photo: Anthony Tieuli
«»
With a 12-inch miter saw, cut 5/16-inch slices from the end of a 5/4x6 piece of cellular PVC trim to use as stand-off blocks. Nail them vertically to the fascia at each rafter location with 18-gauge stainless-steel brads, as shown. Next, snap a chalk line over the blocks where you want the top of the gutter's back edge to go. It should slope toward the downspout location ¼ inch per 10 feet.
Ask TOH users about Drainage & Gutters

Contribute to This Story Below

    Tools List

    • pencil
      Pencil
    • 30-foot tape measure
      Measuring tape
    • brad nailer
      Brad nailer
    • miter saw
      12-inch miter saw
    • four-foot level
      4-foot spirit level
    • chalk line
      Chalk line
    • dust mask
      Dust mask
    • latex gloves
      Latex gloves
    • eye goggles
      Eye protection
    • sandpaper
      80-grit sandpaper
    • respirator
      Organic-vapor respirator
    • drill
      Drill/driver
    • Painter's Tape
      Painter's tape
    • Natural-bristle chip brush
      Chip brush
    • utility knife with hook blade
      Utility knife
    • hole saw
      2 ½-inch hole saw
    • nut driver
      Nut driver

    Shopping List

    Fiberglass gutter

    5/4x6 cellular PVC trim

    18-gauge stainless-steel brad nails

    3 -inch stainless-steel structural screws

    Stainless-steel sheet-metal screws with hex washer head

    Superglue

    Acetone

    Fiberglass mat

    Polyester resin and hardener

    Gelcoat

    Fast-cure marine-grade polyurethane sealant

    Microballoon filler