Step 4: Wrap the Corners

Wrap the corners to make a zinc table top
Photo: James Worrell
«»
To finish a corner, wrap one triangle of zinc around the plywood edge. Wrap the opposing triangle of zinc on top of it and snip off the top triangular piece of metal. Repeat Steps 3 and 4 until all four sides and corners of the tabletop are finished.
Ask TOH users about Furniture

Contribute to This Story Below

    Tools List

    • caulk gun
      Caulk gun
    • utility knife
      Utility knife
    • Aviation Snips
      Tin snips
    • adjustable clamp
      Quick-grip clamps
    • demolition chisel
      Flat 12-inch chisel
    • dead-blow hammer
      Deadblow hammer and clean cloth or rag
    • Soldering gun
    • flat file
      Metal file

    Shopping List

    ¾-inch birch plywood cut to the size of the table you want

    Thin sheet of zinc (0.02 inch thick is best) cut 2 inches wider and longer than the plywood

    Construction adhesive

    Coil of lead-free solder