Step 13: Scribe the Molding.

measuring the inside dimensions of the first coffer
Photo: Ryan Benyi
«»
Measure the interior dimensions of all four sides of the first coffer. On your miter saw, cut inside 45-degree angles on each end of your molding, leaving each piece about ¼ inch too long. Then scribe each piece by holding it in place, as shown, and marking the overhanging material.
Ask TOH users about Ceilings

Contribute to This Story Below

    Tools List

    • 30-foot tape measure
      Measuring tape
    • Painter's Tape
      Painter's tape
    • studfinder
      Stud finder
    • 1/8-inch drill bit
      -inch drill bit
    • drill
      Drill/driver
    • miter saw
      Miter saw
    • pneumatic finish nailer
      Pneumatic nailers (16 gauge and 18 gauge)
    • chalk line
      Chalk line with nonstaining chalk
    • Rafter Square
      Rafter square
    • small plastic putty knife
      Putty knife
    • caulk gun
      Caulk gun
    • 2½-inch sash brush
    • paintroller
      Small paint roller

    Shopping List

    1x6 primed finger-jointed pine. Get six 16-footers.

    Cove-profile shoe molding

    Panel adhesive

    2-inch 16-gauge pneumatic nails

    1 inch 18-gauge pneumatic brads

    Wood shims

    Wood glue

    Wood putty

    Latex caulk

    Semigloss paint