Step 1: Snip The Bead for The Base

step by step how to make a candleholder of drywall corner bead, use tin snips to cut notches for the base «»
Using tin snips, cut notches into the 17-inch bead at about a 30-degree angle every 4 inches along its length, forming V's at 4-, 8-, 12-, and 16-inch intervals.
Ask TOH users about Drywall & Plaster

Contribute to This Story Below

    Tools List

    • metal cutting snips
      Tin snips
    • hand clamps
      Clamps
    • drill
      Drill/driver with -inch and ¼-inch bits for metal
    • Phillips screwdriver
      Phillips-head screwdriver to fasten machine screws
    • locking pliers
      Locking pliers
    • 2x2 wood scrap
      Scrap 2x2 for bending the bead

    Shopping List

    1. One 17-inch length of metal corner bead for the base

    2. Four identical lengths of corner bead for the uprights at the corners. (Ours were 4, 6, and 8 inches tall.)

    3. Four 4-inch lengths of corner bead to form the top

    4. Sixteen #8 ¼-inch machine screws with nuts