Step 4: Create the Corbel Assembly

Create the Corbel Assembly to Build an Address Plaque Post
Photo: Anthony Tieuli
«»
Center the corbel on the L, and trace along the corbel's edges so that you know where to apply adhesive. Remove the corbel. Using a caulk gun, run a heavy bead of polyurethane construction adhesive inside the lines you traced on the boards. Then set the corbel in place, nestling it into the adhesive for good coverage.
Ask TOH users about Driveway & Walkway

Contribute to This Story Below

    Tools List

    • 30-foot tape measure
      Measuring tape
    • miter saw
      Miter saw
    • drill
      Drill/driver
    • Drill bit
      Drill bit
    • Countersink bit
      Countersink bit
    • Lag-screw driver bit
      Lag-screw driver bit
    • caulk gun
      Caulk gun

    Shopping List

    One 6-inch hollow paneled mailbox post designed to fit over a 4x4 post

    1 urethane decorative outdoor-grade corbel

    1 urethane decorative outdoor-grade finial

    1 metal address plaque

    One 8-foot 1x6 cellular PVC board, to pad out the corbel

    Polyurethane construction adhesive

    1¼-inch exterior screws

    2¼-inch exterior screws

    Paintable caulk

    Acrylic paint

    Screw eyes

    2 S-hooks

    1 ground screw (with rebar and lag bolts)

    One 8-foot 4x4 pressure-treated post