Step 9: Upholster the seat.

attaching upholstery fabric to the garden bench seat with a staple gun «»
Starting at the center of one long side, fold the fabric and polyester batting up, tuck in the raw edges, and staple the material in place with a staple gun. Repeat on the side opposite the first staple, pulling the fabric taut but not overly snug before stapling in place. Do the same to the two short ends, then fill in the remaining sides with staples about an inch or so apart. To create clean corners, fold the fabric and batting as you would when wrapping a gift, cutting off excess material so that the corners lie square and neat, then staple in place.
Ask TOH users about Porch

Contribute to This Story Below

    Tools List

    • multi-bit screwdriver
      Screwdriver. Phillips and/or flathead, depending how chair seats are attached
    • flush-cut handsaw
      Flush-cutting saw
    • wooden mallet
      Wood or rubber mallet
    • 16-foot tape measure
      Tape measure
    • circular saw
      Circular saw
    • drill
      Drill/driver
    • 1/4-inch drill bit
      ¼-inch drill bit for pilot holes in bench frame
    • Countersink bit
      Countersink
    • hand clamps
      Clamps
    • sandpaper
      Sandpaper in 60, 150, and 220 grits
    • cleaning rag
      Rag
    • artist paintbrush
      2½-inch nylon paintbrush
    • dress scissors
      Scissors
    • staple gun
      Staple gun
    • 1/8-inch drill bit
      -inch drill bit for pilot holes in seat bottom

    Shopping List

    Two identical vintage chairs

    Poplar 1x4 for bench frame. Get one 8-foot length.

    Poplar 1x1 for cross-support. Get a 3-foot length.

    ¾-inch birch plywood for seat.

    1¼-inch exterior wood screws to secure bench ends to chair backs.

    2-inch exterior wood screws to fasten bench-frame ends to front and back pieces.

    -inch exterior wood screws to fasten bench seat to frame.

    3-inch zinc-plated corner braces. Get four.

    Wood glue

    Wood filler

    Latex primer

    Exterior latex paint. Get two 8-ounce cans.

    Spray adhesive

    2-inch-thick high-density foam rubber, cut to fit

    Polyester batting. Cut to fit seat frame, plus 4 inches on all sides

    1 to 2 yards of weatherproof outdoor upholstery fabric (You'll need more if the fabric has a pattern, to ensure proper alignment.)