Step 17: Install the Steel Rod to Finish

Install the Steel Rod to Finish to Build a Decorative Driveway Marker
Photo: Kolin Smith
«»
Hammer a short length of ½-inch steel rod into the ground where the center post will go. Then, with a helper, lift the assembly and slip the center post over the rod, using the hole you drilled in Step 4.
Next

Related Content

Ask TOH users about Driveway & Walkway
Discuss

Contribute to This Story Below

Add Comment

    More in Exterior

    Tools List

    Close
    • miter saw
      Miter Saw
    • combination square
      Combination Square
    • straightedge guide
      Straightedge
    • Rafter Square
      Rafter Square
    • adjustable clamp
      Clamps
    • circular saw
      Circular saw
    • hand saw
      Handsaw
    • spade bit
      Drill/driver
    • hammer
      ¾-inch Spade Bit
    • chisel
      Hammer
    • mallet
      Chisel
    • mallet
      Mallet
    • 2-and-a-half-inch paintbrush
      Paintbrush

    Shopping List

    Close
    1x3 for the balusters Get four 6-footers.

    6x6 post Get one at least 3 feet long.

    4x4 post Get one at least 3 feet long.

    1x4 for the rails Get two 8-footers.1¼-inch deck screws

    ½-inch threaded galvanized-steel rod

    primer and paint