Step 12: Bevel the Tops of the End Posts

Bevel the Tops of the End Posts To Build a Decorative Driveway Marker
Photo: Kolin Smith
«»
Set your miter saw to 45 degrees. Mark a line all the way around the post, ¾ inch below the top. Clip all four corners along the line, as shown.
Next

Related Content

Ask TOH users about Driveway & Walkway
Discuss

Contribute to This Story Below

Add Comment

    More in Exterior

    Tools List

    Close
    • miter saw
      Miter Saw
    • combination square
      Combination Square
    • straightedge guide
      Straightedge
    • Rafter Square
      Rafter Square
    • adjustable clamp
      Clamps
    • circular saw
      Circular saw
    • hand saw
      Handsaw
    • spade bit
      Drill/driver
    • hammer
      ¾-inch Spade Bit
    • chisel
      Hammer
    • mallet
      Chisel
    • mallet
      Mallet
    • 2-and-a-half-inch paintbrush
      Paintbrush

    Shopping List

    Close
    1x3 for the balusters Get four 6-footers.

    6x6 post Get one at least 3 feet long.

    4x4 post Get one at least 3 feet long.

    1x4 for the rails Get two 8-footers.1¼-inch deck screws

    ½-inch threaded galvanized-steel rod

    primer and paint