Step 14: Assemble the Column.

assembling the column of a columned room divider
Photo: Ryan Benyi
«»
Countersink pilot holes through the tops of the column assembly and into the upper blocking, then screw them in place with MDF screws. At the bottom, tack the panels to the lower blocking with brad nails. Then glue and secure the two remaining sides of the column in the same fashion.
Next

Related Content

Ask TOH users about Cabinets & Shelving
Discuss

Contribute to This Story Below

Add Comment

    More in Interior

    Tools List

    Close
    • 100-foot tape measure
      Tape measure
    • straightedge guide
      Straightedge
    • bar clamp
      Clamps
    • circular saw
      Circular saw
    • caulk gun
      Caulk gun
    • drill
      Drill/driver
    • Countersink bit
      Countersink bit
    • four-foot level
      4-foot level
    • pneumatic brad nailer
      Pneumatic brad nailer and air compressor
    • combination square
      Combination square
    • miter saw
      Miter saw

    Shopping List

    Close
    ¾-inch medium-density fiberboard (MDF)
    Get three 4-by-8-foot sheets for an 8½-foot ceiling.

    2x8 lumber to build the base

    Shims

    Solid crown molding to trim the capital and the cabinet top

    Baseboard molding

    ½-inch and ¾-inch quarter-round molding
    for the base cap and shoe molding

    1½-inch MDF screws to assemble the boxes

    2½-inch deck screws to install the base and the blocking

    1¼-inch brad nails

    Construction adhesive

    Wood filler and paintable caulk

    Primer and paint