Photo: Tina Rupp
«»
Build a jig to hold the cans steady while you work. Screw scrap 1x1s to the long sides of a board (we used a 1x6).
Step 2: Create a Steady Surface
Introduction
Step 1
Plug Cans with Ice
Step 2
Create a Steady Surface
Step 3
Draw Designs
Step 4
Punch out The Design
Step 5
Attach a Handle
Step 6
Add a Light
More in Exterior
Tools List
-
Hammer
-
Awls in various sizes
-
Chisels in various sizes
-
3-inch spring clamp
-
Pliers
-
Marker
Shopping List
Metal cans in various sizes
Clean paint cans (if desired)
Scrap 1x1s (leftover molding works too) about 10 inches long
A scrap 1x6 at least as long as your tallest can
18- to 21-gauge wire
Tea lights
Clean paint cans (if desired)
Scrap 1x1s (leftover molding works too) about 10 inches long
A scrap 1x6 at least as long as your tallest can
18- to 21-gauge wire
Tea lights
Contribute to This Story Below