Photo: Laura Moss
«»
Fit your drill/driver with a bit that's slightly smaller than the screw's shank, steady it on the marks on the wood trim, and bore holes for the lag screws.
Step 4: Drill Pilot Holes for the Handle Posts
Introduction
Overview
Step 1
Seal the Wood
Step 2
Measure for the Spigot-Handle Hooks
Step 3
Mount the Handles on the Screw Posts
Step 4
Drill Pilot Holes for the Handle Posts
Step 5
Secure the Posts
Step 6
Add the Spring Clips and Hanging Your Rack
More in Remodels & Upgrades
Tools List
-
Measuring tape
-
Combination square (optional)
-
Drill/driver
-
Socket wrench
-
Screwdriver
Shopping List
Reclaimed molding
Clear polyurethane spray (satin sheen)
Spigot handles
Spring clips and screws¼-inch galvanized lag screws and corresponding nylon spacers
Hanging hardware
Clear polyurethane spray (satin sheen)
Spigot handles
Spring clips and screws¼-inch galvanized lag screws and corresponding nylon spacers
Hanging hardware
Contribute to This Story Below