Step 3: Mount the Handles on the Screw Posts

Mount the Handles on the Screw Posts to Build a Spigot-Handle Tool Rack
Photo: Laura Moss
«»
Insert lag screws through the handles' center holes, and twist on the nylon spacers. If a hole is too small, clamp the handle to your work table, put a ¼-inch bit in the chuck of a drill/driver, and widen it.
Ask TOH users about Salvage

Contribute to This Story Below

    Tools List

    • 30-foot tape measure
      Measuring tape
    • combination square
      Combination square (optional)
    • drill
      Drill/driver
    • socket wrench
      Socket wrench
    • multi-bit screwdriver
      Screwdriver

    Shopping List

    Reclaimed molding

    Clear polyurethane spray (satin sheen)

    Spigot handles

    Spring clips and screws¼-inch galvanized lag screws and corresponding nylon spacers

    Hanging hardware