Step 13: Add the Finishing Touches

installing the shoe molding for a storage bed
Photo: Laura Moss
«»
Use a miter saw to cut shoe molding for each side, straight at the headboard end and angled at 45 degrees at the footboard end. Use a brad nailer to fasten the shoe in place. Measure, cut, and install the footboard piece, as shown. Fill any nail holes, then sand and paint the bed. Before you know it, it'll be time to hit the hay.
Next

Related Content

Ask TOH users about Furniture
Discuss

Contribute to This Story Below

Add Comment

    More in Interior

    Tools List

    Close
    • bar clamp
      Long bar clamps
    • straightedge guide
      Straightedge
    • circular saw
      Circular saw
    • impact driver
      Drill/driver or impact driver
    • paintbrushes
      Paintbrushes
    • miter saw
      Miter saw
    • brad nailer
      Brad nailer or nail gun
    • japanese pull saw
      Jigsaw or Japanese handsaw
    • paintroller
      Paint roller and tray
    • caulk gun
      caulk gun

    Shopping List

    Close
    ¾-inch medium-density fiberboard (MDF)
    Get five 4-by-8-foot sheets.

    ⅜-inch MDF beadboard panelsGet two 4-by-8-foot sheets.

    1x2 primed MDF trim
    Get eleven.

    8-foot lengths for the stiles, rails, and cap.

    2x4s
    Get three 8-footers.

    Victorian-era door-casing kit (includes rosettes)½x3 lattice strip shoe molding
    Get 20 feet.

    1¼-, 1½-, and 2-inch MDF screws

    2½-inch deck screws

    1½-inch 18-gauge brads

    Construction adhesive

    Wood glue

    ¾-inch quarter-round

    150-grit sandpaper

    Primer and paint