Step 6: Mark the Cutlines on the Seat Blank

marking the cut lines for the seat of a Westport chair
Photo: Wendell T. Webber
«»
Use a straightedge to mark the cutlines on the seat blank per the parts plan. These odd-shaped cuts allow the seat to fit precisely into the tapered space between the front and back legs.
Next

Related Content

Ask TOH users about Furniture
Discuss

Contribute to This Story Below

Add Comment

    More in Interior

    Tools List

    Close
    • miter saw
      Sliding compound miter saw to crosscut the boards to length
    • adjustable clamp
      Clamps to hold the parts together during assembly
    • circular saw
      Circular saw to cut the parts to width
    • framing square
      Framing square and combination square for marking cutlines
    • jigsaw
      Jigsaw to cut notches and curves
    • drill
      Drill/driver
    • hand plane
      Hand plane to straighten board edges
    • sandpaper
      120-grit sandpaper
    • sanding block
      Sanding block
    • pencil compass
      Compass
    • torpedo level
      Torpedo level
    • 3-inch wide paint brush
      3-inch paintbrush to apply teak oil

    Shopping List

    Close
    ½ x 10 cedar boards.
    Get four 8-foot lengths

    1 ⅝-inch stainless-steel trim-head screws

    Teak oil to finish the chair