Step 7: Cut the Pieces

cutting the cladding of one of the 1x6 lamppost arms
Photo: Kolin Smith
«»
Set the miter saw to 45 degrees and trim the arms at the cutlines you marked. Next, you'll cut the four 1x6 boards to clad the center post. First, though, bevel one end of each board at 45 degrees and use those ends to make the short pieces that fit directly above the lantern arm.
Ask TOH users about Outdoor Structures

Contribute to This Story Below

    More in Landscaping

    Tools List

    • miter saw
      sliding-compound miter saw
    • drill
      drill/driver
    • circular saw
      circular saw to cut wiring channel
    • cold chisel
      ¾-inch chisel to clear waste wood from wiring channel
    • hammer
      hammer
    • combination square
      combination square
    • caulk gun
      caulking gun
    • pneumatic finish nailer
      pneumatic finishing nailer
    • flush-cut handsaw
      flush-cutting handsaw to trim dowel rods
    • sledge hammer
      3-pound sledgehammer to set lamppost
    • two-foot level
      2-foot level
    • random orbit sander
      random-orbit sander

    Shopping List

    24 common cedar board. Get one 8-footer to make the center post and lantern arm.

    16 clear cedar boards. Get two 8-foot lengths to clad the post.

    210 clear cedar board. Get one 6-footer to wrap the base of the post.

    construction adhesive

    2- and 2½-inch-long finishing nails for a pneumatic nailer

    -inch hardwood dowel

    -inch-diameter spade bit waterproof carpenter's glue to glue dowel rods in place

    polyurethane glue for mitered joints on the decorative base

    100-grit disks for the random-orbit sander

    1-inch screw hook for hanging the lantern or light fixture

    copper candle lantern

    low-voltage land-scape light fixture (optional)

    transformer (optional)

    12-volt cable (optional)

    cable staples (optional)