Weekend Remodel: How to Install Wainscoting

By: Jennifer Stimpson, This Old House magazine

Shopping List

Supplies You Will Need

Painter's tape

¼inch plywood.
Get enough to cover the entire area of your wainscoting with the grain running vertically.

1x4 for the stiles

1x5 for the corner stiles

1x6 for the bottom rail.

1x8 for the top rail and baseboard.
Get enough to cover each wall twice.

Stool for the chair-rail cap.
Choose a profile deep enough to extend beyond the layered depth of the plywood, rail, and apron.

Casing for the apron

Panel molding to trim the panels

Base-cap molding

Shoe molding

Panel adhesive

2½-inch finishing nails to install the stiles, rails, baseboard, apron, and chair rail

1½-inch finishing nails to install the panel, base cap, and shoe moldings

Wood glue

Wood filler

Adhesive latex caulk.
Choose primed boards and molding to save time.

Close
Tools List
Tools You Will Need
- utility knife
- pry bar
- chalk line or straightedge to mark cuts on the plywood
- 4-foot level
- circular saw
- caulk gun
- stud finder
- nail gun
- miter saw
- flush-cut saw to back-cut existing moldings
- Speed Square
- chisel
Close

placing the trim for the wainscoting panels

< >

Photo: Ryan Benyi

Introduction
Overview
Steps:
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
- 11
- 12
- 13
- 14
- 15
- 16
- 17
- 18

17: Trim Out the Panels

17. Trim Out the Panels

Miter panel molding at 45 degrees to line the inside edges of the panels. If your molding is delicate, like ours, just glue it in place. For thicker trim, nail it in place with a nail gun and 1½-inch finishing nails. Once all the pieces are installed, fill all nail holes with wood filler, and joints with latex caulk. Let dry. Sand the surfaces, prime the plywood, and finish the project with several coats of paint.