Step 7: Install the Rear Support

Tom Silva installs the rear support
Photo: Anthony Tieuli
«»
Apply wood glue along the perimeter of the unpainted side of the rear support. Tip the piece into the planter and pull it snug against the inside of the lip so that the glue makes contact.
Next

Related Content

Ask TOH users about Storage
Discuss

Contribute to This Story Below

Add Comment

    More in Living Spaces

    Tools List

    Close
    • drill
      Drill/driver
    • brad nailer
      Brad-nail gun
    • miter saw
      Miter saw
    • finish hammer
      Hammer and pliers to knock out the bottom of the planter and remove nails

    Shopping List

    Close
    1. Planter box

    2. ¼-inch plywood
    Get a piece large enough to create two pieces sized to the height and width of the planter's opening.

    3. 1x2 to make scrap blocks or attachment strips for the bottle holders

    4. Wood glue to secure the bottle holder 5. ⅝-inch brad nails to secure the strips

    6. 220-grit sandpaper

    7. Dark spray paint for the planter's interior (we used black)

    8. Primer and satin or semigloss paint