Step 9: Attach the Front Stops

Attaching the front stops to build panels
Photo: Kolin Smith
«»
Lay the frame pieces of one panel on the work surface. Place a corresponding strip on each board, centered end-to-end for the front stop. Now use a scrap piece of the strip material to recess the stops 3⁄4 inch from the front edge of each board. Tack them in place using a nail gun and 1¼-inch nails, and screw them to the board using a drill/driver and 1-inch screws.
Ask TOH users about Fences & Stone Walls

Contribute to This Story Below

    Tools List

    • nylon mason's line and stakes
      Mason line and stakes
    • post hole digger
      Posthole digger
    • hand clamps
      Clamps
    • four-foot level
      4-foot level
    • miter saw
      Miter saw
    • pneumatic brad nailer
      Pneumatic brad nail gun
    • circular saw
      Circular saw (fitted with a rip fence)
    • drill
      Drill/driver (fitted with -inch paddle bit)

    Shopping List

    1. 4×4 pressure-treated posts
    Get them long enough to go below the frost line; at least one-third of each post must be buried.

    2. Cedar 1×6 lumber
    To be ripped to make the post sleeves, stops, and cap rail.

    3. Cedar square lattice
    Get 4-by-8 sheets that can be cut into two panels each.

    4. Self-adhesive flashing to protect the portion of the post set in concrete.

    5. ¾-inch drainage stone

    6. Concrete
    Choose a fast-setting mix.

    7. 1¼-inch exterior grade brad nails

    8. 1-inch trim-head stainless-steel deck screws

    9. 3-inch stainless-steel deck screws

    10. Polyurethane glue

    11. Polyurethane construction adhesive

    12. Painter's tape

    13. Post caps
    Get 5¼-inch post caps to fit over the sleeved 4×4 posts.