Step 8: Trim the Hutch

Tom Silva attaches molding to trim the hutch
Photo: Allison Dinner
«»
Cut trim to size, mitering the corners. Nail trim to the top and bottom edges of the hutch's front and sides. Nail hardboard to the back of the hutch. Attach self-stick cabinet-door bumpers to the hutch's underside before placing it on the desktop.
Ask TOH users about Furniture

Contribute to This Story Below

    Tools List

    • circular saw
      Circular saw
    • miter saw
      Miter saw
    • utility knife
      Utility knife
    • straightedge guide
      Straightedge
    • drill
      Drill/Driver
    • brad nailer
      Brad nailer

    Shopping List

    1. ½-inch plywood to make the desktop, back, sides, and cubby.
    Get a 4x8-foot sheet.

    2. 1x3 to make the apron.
    Get a 3-foot piece.

    3. 1x2 to make the cleats.
    Get two 8-foot boards.

    4. ¾-inch molding to trim the hutch.
    Get two 6-foot lengths.

    5. 1-inch molding to trim the desktop's front and sides.
    Get two 6-foot lengths.

    6. 29-inch legs.
    Get four.

    7. Acrylic sheeting.
    Get a piece you can cut to 27 by 48 inches.

    8. Small cabinet to make into a hutch.
    We used a ClosetMaid 3-Shelf 12-inch Wood Laminate Storage cabinet with door from Lowe's.9. ¼x5 lumber to make mail-slot dividers for the hutch.
    Get at least 4 feet.

    10. Hardboard.
    Get a piece the size of the back of the cabinet; you'll attach it to the hutch in place of the cabinet's back, which isn't designed to take paint.

    11. 1-inch brad nails

    12. 1 -inch brad nails

    13. 1-inch screws

    14. 2-inch screws