Step 14: Assemble the Sides

Mark Powers fastens the sides of the hypertufa table together with a pneumatic nail gun
Photo: Wendell T. Webber
«»
One by one, lift each piece that's on top, apply polyurethane glue to its back, and set it back in place. Tack the pieces together using a pneumatic nail gun and 1-inch brad nails. Repeat for the second side.
Ask TOH users about Outdoor Structures

Contribute to This Story Below

    More in Landscaping

    Tools List

    • miter saw
      miter saw
    • jigsaw
      jigsaw
    • drill
      drill/driver to assemble the form.
    • utility knife
      utility knife for cutting the foam.
    • aviation snip
      wire snips
    • mixing tub
      mixing tub to make the hypertufa mix.
    • masonry hoe
      hoe
    • Natural-bristle chip brush
      chip brush to spread petroleum jelly on the interior of the form before casting the tabletop.
    • finish hammer
      hammer
    • pneumatic finish nailer
      pneumatic nail gun

    Shopping List

    1. 1x4 scrap lumber for the form.

    2. cedar 1x4s for crosspieces and stretchers.

    3. cedar 1x2s for legs and support blocks.

    4. 1¼-inch and 2-inch deck screws

    5. perlite Get two bags.

    6. peat moss Get one large bag.

    7. portland cement Get a 47-pound bag.

    8. acrylic fortifier for the hypertufa mix, to prevent cracking. 9. ¾-inch rigid-foam insulation

    10. petroleum jelly or cooking spray to coat the interior of the form.

    11. ¼-inch hardware cloth

    12. plastic sheeting to cover the form while the tabletop cures.

    13. polyurethane glue, such as Gorilla Glue.

    14. 1-inch brad nails

    15. dust mask and protective gloves