Step 1: Cut the Pieces for the Form

Mark Powers cuts pieces for a hypertufa table with a miter saw
Photo: Wendell T. Webber
«»
Refer to the cut list. Use a miter saw to cut scrap 14s into long sides, short sides, and reinforcing blocks.
Ask TOH users about Outdoor Structures

Contribute to This Story Below

    More in Landscaping

    Tools List

    • miter saw
      miter saw
    • jigsaw
      jigsaw
    • drill
      drill/driver to assemble the form.
    • utility knife
      utility knife for cutting the foam.
    • aviation snip
      wire snips
    • mixing tub
      mixing tub to make the hypertufa mix.
    • masonry hoe
      hoe
    • Natural-bristle chip brush
      chip brush to spread petroleum jelly on the interior of the form before casting the tabletop.
    • finish hammer
      hammer
    • pneumatic finish nailer
      pneumatic nail gun

    Shopping List

    1. 1x4 scrap lumber for the form.

    2. cedar 1x4s for crosspieces and stretchers.

    3. cedar 1x2s for legs and support blocks.

    4. 1¼-inch and 2-inch deck screws

    5. perlite Get two bags.

    6. peat moss Get one large bag.

    7. portland cement Get a 47-pound bag.

    8. acrylic fortifier for the hypertufa mix, to prevent cracking. 9. ¾-inch rigid-foam insulation

    10. petroleum jelly or cooking spray to coat the interior of the form.

    11. ¼-inch hardware cloth

    12. plastic sheeting to cover the form while the tabletop cures.

    13. polyurethane glue, such as Gorilla Glue.

    14. 1-inch brad nails

    15. dust mask and protective gloves