Step 6: Cut the First Molding Strip

tom silva and reader cutting molding strips for magazine file
Photo: Allison Dinner
«»
Mark a length of molding for one side edge of the back. To cut the lower end where it meets the base, lay the molding flat on the saw deck and miter it at 45 degrees, like a picture frame. At the top corner, stand the molding on edge and miter it at 45 degrees, like a bevel.
Ask TOH users about Storage

Contribute to This Story Below

    Tools List

    • hammer
      Hammer
    • chisel
      Chisel
    • 16-foot tape measure
      Tape measure
    • circular saw
      Circular saw
    • miter saw
      Miter saw
    • pneumatic brad nailer
      Pneumatic nail gun
    • sandpaper
      Sandpaper

    Shopping List

    Brackets Pick a bracket slightly larger than the magazine you plan to store, with scrollwork that extends enough to keep the corners from flopping over.

    1x boards Select boards at least as wide (plus ¼ inch) as the bracket is long.

    Molding Choose a profile up to ¾ inch to cover the exposed edges of the 1x boards. It's okay if it's slightly smaller; that will create a subtle reveal. Wood glue

    1¼-inch brad nails to attach the back to the base.

    -inch brad nails to attach the molding to the edges of the base and back.

    Wood filler

    Primer spray paint

    Semigloss spray paint