Step 3: Assemble the Base and Back

tom silva and reader assembling base and back for magazine file
Photo: Allison Dinner
«»
Apply wood glue to the rear edge of the base piece, and butt it against the back piece. Using a hammer and 1¼-inch finishing nails, or a pneumatic nail gun and 1¼-inch brad nails, fasten through the back and into the base.
Next

Related Content

Ask TOH users about Storage
Discuss

Contribute to This Story Below

Add Comment

    More in Living Spaces

    Tools List

    Close
    • hammer
      Hammer
    • chisel
      Chisel
    • 16-foot tape measure
      Tape measure
    • circular saw
      Circular saw
    • miter saw
      Miter saw
    • pneumatic brad nailer
      Pneumatic nail gun
    • sandpaper
      Sandpaper

    Shopping List

    Close
    Brackets Pick a bracket slightly larger than the magazine you plan to store, with scrollwork that extends enough to keep the corners from flopping over.

    1x boards Select boards at least as wide (plus ¼ inch) as the bracket is long.

    Molding Choose a profile up to ¾ inch to cover the exposed edges of the 1x boards. It's okay if it's slightly smaller; that will create a subtle reveal. Wood glue

    1¼-inch brad nails to attach the back to the base.

    ⅝-inch brad nails to attach the molding to the edges of the base and back.

    Wood filler

    Primer spray paint

    Semigloss spray paint