Step 16: Miter the Cap Pieces

Miter the Cap Pieces to make a planter bench
Photo: Kolin Smith
«»
On a 1¼x6 board, use a Speed Square to draw opposing 45-degree angles so that the distance from short point to short point equals the inside edge of the tall planter. Using a circular saw guided by the Speed Square, cut the lines. Repeat to create three additional cap pieces.
Ask TOH users about Outdoor Structures

Contribute to This Story Below

    More in Landscaping

    Tools List

    • four-foot level
      4-foot level
    • miter saw
      miter saw
    • circular saw
      circular saw
    • jigsaw
      jigsaw
    • speed square
      Speed Square
    • drill
      drill/driver fitted with a -inch paddle bit
    • square spade
      garden spade
    • hammer
      hammer
    • tamper
      hand tamper
    • caulk gun
      caulk gun

    Shopping List

    1. cedar 2×4s Get twenty 8-foot boards to make the 16½-inch planter pieces and the 82½-inch-long seat frame.

    2. cedar 1¼×6s Get four 6-foot boards to make the 63-inch-long seat, and one 8-foot board to trim the tall planter.

    3. ¾-inch gravel for drainage below the planters and to fill the assembled planters. Get at least 1½ cubic feet (three bags).

    4. potting soil to top off the planters filled with gravel. Get four 32-quart bags.5. construction adhesive Get 4 tubes.

    6. 3-inch stainless-steel deck screws

    7. 2-inch stainless-steel deck screws

    8. 3-inch galvanized siding nails

    9. 12-inch galvanized spikes Get eight