Step 7: Attach the apron

two men attaching apron on poker table
Photo: Ryan Benyi
«»
Slice ¼-inch spacers off a scrap block using the miter saw, and set them on top of the outer ring of 1x2s. Position a 1x4 against the edge of the table with its top edge flush with the spacers to create a ¼-inch lip. Mark the corners of the table on the top edge of the 1x3. Using a miter saw, bevel the ends of each piece at a 22½-degree angle. Secure the pieces to the edges of the table using wood glue and 1¼-inch nails.
Ask TOH users about Furniture

Contribute to This Story Below

    Tools List

    • circular saw
      Circular saw
    • miter saw
      Miter saw
    • combination square
      Combination square
    • pneumatic brad nailer
      Pneumatic nail gun
    • drill
      Drill/driver, 3-inch hole saw bit, -inch pilot bit, combination countersink bit, and -inch paddle bit
    • staple gun
      Staple gun fitted with -inch staples
    • utility scissors
      Utility scissors
    • adjustable clamp
      Clamps

    Shopping List

    1. ½-inch oak plywood to make the lid and table: Get one 4x8-foot sheet.

    2. Nose and cove oak molding to trim the lid. Get two 8-foot lengths.

    3. 1x2 oak to trim the table. Get four 8-foot lengths.

    4. 1x4 oak to make the table's apron and collar. Get two 8-foot boards.

    5. x6 oak to make the coasters. Get three 2-foot boards.

    6. ¾-inch medium-density fiberboard (MDF) to make the playing surface. Get one 4x4-foot half sheet.

    7. Newel post to make the stand. Get an oak post at least 30 inches tall.

    8. Corbels to make the feet. Get four @ 10 inches.9. Felt. Get a 4x4-foot piece to cover and wrap the edges of the playing surface.

    10. Spray adhesive to attach the felt to the playing surface.

    11. -inch brad nails

    12. 1-inch brad nails

    13. 1¼-inch brad nails

    14. 2-inch deck screws

    15. 6-inch timber screws to attach the corbels to the newel post. Get eight.

    16. Wood glue

    17. 150- and 220-grit sandpaper