Step 16: Secure the Base Molding

attaching base molding to the cocktail hutch
Photo: Ryan Benyi
«»
  Using a miter saw, bevel the ends of the front strip of base molding and the front ends of the side pieces. Straight-cut the back ends of the side pieces. Apply glue to the back of each piece. Nail them in place flush with the bottom edge of the sides using 1½-inch nails. Fill all the nail holes and joints with wood filler, and sand and paint the entire assembly.
Next

Related Content

Ask TOH users about Cabinets & Shelving
Discuss

Contribute to This Story Below

Add Comment

    More in Interior

    Tools List

    Close
    • miter saw
      Miter saw
    • circular saw
      Circular saw
    • jigsaw
      Jigsaw
    • speed square
      Speed Square
    • combination square
      Combination square
    • drill
      Drill/driver
    • pneumatic brad nailer
      Pneumatic nail gun

    Shopping List

    Close
    1. 1x15 edge-glued shelving. Get four 6-foot boards and one 3-foot board to make the sides, top, bottom, shelves, and wine-rack insert.

      2. 1x3 to create support strips for the bottom board.

      3. ⅝-inch square dowels to make the glass rack. Get two 3-foot lengths.

      4. ⅜x3 lattice strips to make the glass rack. Get two 3-foot lengths.

      5. 3¼-inch baseboard molding: Get a 6-foot length.

      6. 3⅝x9/16-inch crown molding: Get a 6-foot length.  7. 2x4 to make the backing strips for the crown molding

      8. 1x2 to make the face-frame stiles: Get two 6-foot boards in clear pine.

      9. 1x5 to make the face-frame rails: Get at least 3 feet in clear pine.

      10. 5mm lauan for the backing. Get one 4x8 sheet.

      11. 1½-inch brad nails

      12. ⅝-inch brad nails

      13. 1¼-inch drywall screws